electrical

  1. rc_heli_nut

    [How To] The FI fuse

    If you remove the FI fuse in the skinny fuse block above the battery, the NT will crank but not start, assuming the kill switch is in Run position. With this fuse out the PGM-FI module doesn't receive switched 12v, so the fuel pump, injectors, and ignition coils won't be active. I verified...
  2. Pick

    [Review] Healtech GIPRO DS Gear indicator installed

    Wow, I did a nice farkle today after reading some other posts about it. I installed the Healtech GIpro DS gear indicator (GPDS-H01). It was fairly easy -- otherwise I wouldn't have been able to do it. Thanks to Katherine and others, I was able to locate the DLC connector on the left side in...
  3. [How To] Eastern Beaver PC-8 Fuse Panel Install

    I wanted to run every electrical accessory off of a fuse panel including a full set of Gerbing's heated clothing. I opted to use the PC-8 fuse panel from Eastern Beaver. It is capable of 15amp continuous draw from each circuit and is a quality piece of hardware with a ton of support from the...
  4. tawilke46

    [How To] Corbin Seat Fix for Fuzeblock

    Finally got around to taking a Dremel and a file to the seat pan on the Corbin.šŸ˜„ Used Katherine's suggestion of using putty to locate where I needed to take out seat pan material. Scribed marks (slightly larger than Fuzeblock outside dimensions) where I needed to cut and went to using the...
Back
Top Bottom